@noodles perhaps that’s by design then. This happens to be a `public_html`

@pndc @mwl @noodles my plan for it is purely to use it as a vehicle for invoking crm114; I may disable all the other tests, hopefully I can avoid its performant pain points

@zhenech I did :) 🍦

@zhenech good ices

since input shaping is (I think) encoded in the GCODE, I could print an old sliced GCODE from before and see what happens. I'll try to find one.

I can't reliably print on my Prusa Mini+ any more and I haven't since they introduced input shaping.

I don't know if that's what the problem is, but I'm ruling out most other possibilities: I've just done a nozzle clean and a cold pull, no avail

@RogerBW @pndc gotcha, thanks. That's my setup atm, I'm looking at SMTP-time crm114 now, probably via SA.

@RogerBW @pndc do you invoke crm114 via SA?

@noodles @pndc I think that's the system that is recommended in @mwl's email book. Likewise I'm squinting at the base level complexity

@ilmari well, I say "working". neither side is complaining, but the graphs for the slaves are blank. Sigh. a rollin' up my sleeves I go!

@pwaring oh! I’m “glad” there’s some progress to the situation, although not sure I’m glad what the outcome is. I’ll read your post now

Happy “two weeks of chaos whilst the world slowly settles into daylight savings time” for those who celebrate

Dann, my 3d printer isn’t working again.

@emily `alias please=sudo`

@ilmari it took longer than I thought but I added a smokeping slave today. Interesting design: master sends Perl to slaves to execute

In the case of SA, I’m not planning on using its actual filter rules, but it’s a method of connecting Exim and crm114. I guess I could swap out crm114 but I’ve been so happy with it. Another tool for this job is https://github.com/jmtd/crm114-spamd/blob/master/crm114-spamd.c. But it’s a lot less battle tested than SA